Assemble Sliding Weight Post in assembly Step-6
The triangular bracket on the Sliding Weight Post (Part #23) must be facing up and toward to back.
Weight Bar Assembly Note
NOTE: Help of another person is strongly recommended for this step. Place the Lifting Sleeve (#28)
in between the two Safety Stop Frames (#25). Align the holes. Insert the Weight Bar (#29) into the
Safety Stop Frame from one end and through the Lifting Sleeve (#28) to the other Safety Stop Frame
on the opposite side. Secure the Weight Bar to each Safety Stop Frame with two pre-installed M8 x
3/8” Allen Bolts (#104) on each Safety Stop Frame. Ensure the Bolts are fastened so the Weight Bar
won’t slide through the Safety Stop Frame.
To Next Page
