Need help?Do you have a question about the Mariner 20 HP and is the answer not in the manual?
General| Horsepower | 20 HP |
|---|---|
| Cylinders | 2 |
| Ignition System | CDI |
| Starting System | Manual |
| Gear Shift | Forward, Neutral, Reverse |
| Shaft Length | 15" |
Locates and describes the motor's lift handle.
Explains the importance of transom height for performance.
Details the process of securing the motor to the boat transom.
Describes the manual procedure for tilting the motor up.
Explains how to adjust the tilt pin for optimal boat handling.
Describes the function of the tilt lock lever.
Explains how to adjust the trim tab for steering pull compensation.
Covers battery installation and electrical accessory connection.
Details fuel tank placement and fuel line connection.
Guides on choosing the best propeller for operating conditions.
Information on repairing damaged propellers.
Instructions for correctly installing a propeller.
Explains how weight placement affects boat handling and performance.
Outlines conditions for the boat bottom to maintain speed.
Describes the function of the primer and fast idle control.
Details the functions of the tiller handle for steering and control.
Explains how to adjust throttle friction for speed holding.
Details the function and use of the emergency stop switch.
Describes the procedure for shifting between forward, neutral, and reverse.
Explains the correct procedure for stopping the motor.
Instructions on how to engage the shallow water troll feature.
Instructions on how to disengage the shallow water troll feature.
Identifies and describes key components of the remote control system.
Lists pre-operation checks and procedures before starting the engine.
Provides step-by-step instructions for starting the engine.
Explains how to control speed and shift gears using the remote.
Details the procedure for stopping the motor using the remote control.
Lists pre-operation checks and procedures before starting the engine.
Provides specific instructions for starting a cold engine.
Provides specific instructions for starting a warm engine.
Explains how to control speed and shift gears using the remote.
Details the procedure for stopping the motor using the remote control.
Instructions for removing the motor's top cowl.
Instructions for installing the motor's top cowl.
Details inspection, cleaning, and replacement of spark plugs.
Explains how to adjust the low speed mixture screw.
To Next Page
