19
For more information on using the teach ir function of the
Nº360S, see “Remote Control of the Nº360S”
9 Standby & Standby LED
Pressing this button takes the Nº360S out of “standby” mode
(provided the Nº360S is connected to AC power), making it fully
operational.
Pressing
standby again places the Nº360S into standby mode,
which turns the display off, turns off all outputs (including the
record outputs), and disables the front-panel controls. The inter-
nal circuitry remains powered up in order to maintain its thermal
stability and optimum performance at all times.
While the Nº360S is in standby, the LED above the standby button
flashes approximately every five seconds. When the Nº360S is
ready to operate (that is, when it is not in standby mode), this
LED remains lit continuously.
To Next Page
Loading...