7
Operating Voltage
The Nº360S Digital Audio Processor is set at the factory (internally) for
100V, 120V, 220V, 230V or 240V AC mains operation @ 50 or 60Hz.
(230V/50Hz only in European Union countries, in compliance with CE
regulations.) This voltage setting cannot be changed by the user. Make
sure that the label on the bottom panel of the Nº360S (adjacent to the
AC cord) indicates the correct AC operating voltage for your location.
If the voltage indicated on your Nº360S is incorrect, or if you wish to
change the AC operating voltage of your Nº360S as the result of mov-
ing to a different country than the one in which you purchased your
digital audio processor, see your Mark Levinson dealer.
The Nº360S can be powered by a normal 15-ampere AC mains line. If
other devices are also powered from the same AC line, their additional
power consumption should be taken into account.
For optimal sonic performance and longevity, the Nº360S is designed
to remain powered at all times (the
standby switch merely mutes the
processor’s outputs and turns off the display). There is an initial break-
in period of approximately 300 hours before the Nº360S achieves opti-
mum performance.
To Next Page
Loading...