Markibar IZAGA KEY - Problem Solving Guide

Página nº 16 de 25
7.- Problem solving.
PROBLEMA CAUSA SOLUCION
The grinder is off. Display
is off.
The differential switch or
current limiting circuit breaker
has been tripped.
Reset the installation's
protective device.
The electrical cord is not
connected.
Plug the electrical cord int
o the
socket.
Blown fuse in the equipment.
Check the fuse and replace if
necessary.
The grinder is connected
but it doesn't turn, so it
doesn't grind.
Grinding level too fine.
Set a coarser grinding level.
Grind some coffee and gradually
return to the desired level.
A foreign object prevents the
machine from grinding.
Proceed as in the previous
section. Contact the Technical
Assistance Service if the device
does not turn freely.
The grinder does not
start. Display is on.
Overheating due to excessive
motor use.
Wait for the device to cool down
and for the thermal protective
device to be automatically reset.
The grinder starts and
turns, but does not make
coffee.
The bean hopper is jammed or
the inlet hopper is closed.
Check both the inlet hopper and
the bean hopper.
The device grinds very
slowly.
The grinding burrs are worn out.
Replace the burrs.
In case of other anomalies or continuous malfunction contact TAS
(Technical Assistance Service).