6
3. Awning with motor drive
3.1
The electrical connection for motor drive
and/or controller connection is to be carried out as
prescribed by the motor and controller
manufacturer. Modifications, in particular
concerning the motor, the controller and the
connection lead require written authorization.
The installation and setting guide is attached to
the power supply cable of the motor. Instructions
for other electrical components are to be found in
the appropriate packaging.
The integrated motor has a learned end position in
the extending direction. This setting is carried out
at works. If it needs to be altered or corrected, one
must proceed according to the motor instructions
(with radio: portable transmitter, without radio:
setting cable)
Direction of rotation when retracting
ATTENTION: A coiling of the cover onto the roller
from below can lead to the awning being damaged
when retracted. When altering the end positions,
definitely observe the direction of rotation.
3.2
If required, the Hirschmann plug can be
situated behind the side panel. (Not possible with
the Studio variant!)
Remove side panel inside (there are four small
snaplocks at the edge, which grip behind the outer
side panel). Unscrew the sheet metal screws with
cross slot for securing the side panel outside. Place
the Hirschmann plug in the side panel, shorten the
cable if necessary.
To Next Page
Loading...
