Markilux 6000 - Fixture Covers Installation; Face Fixture Cover Fitting

8
5.3 Raise arm and relieve the load. By turning the
socket head cap screw (SW 4), bring the arm to the
horizontal position.
5.4 Tighten socket head cap screws SW 4 (1) and
SW 10 (2) on the inner bracket.
6. Fixture covers
6.1 Face fixture cover
6.1.1 From an awning pitch angle of approx. 15°,
it is necessary to cut out the plastic covers of the
wall fixtures at the thin-walled bridges with a
safety knife according to the pitch angle setting.
Screw on wall cover.
6.1.2 Screw on wall cover with socket head cap
screw (SW 5).