11
The LED lighting can heat up a lot. The lighting has to be switched o for some some minutes to cool down before you touch the
individual lamps.
You must never hang any objects or similar in front of the lamps, and it should be ensured that there are no objects immediately
underneath the front profile both in retracted and in extended state.
Observe in particular the safety clearances in "Important notes".
Do not grab or pull the mains leads (230 V). No objects must be suspended from these mains leads.
The mobility of the mains lead is limited in temperatures below zero. Therefore it has to be ensured, whether the electrician has protected
the connection of your lighting via an RCCB (30mA), so that any eventual cable breakage does not pose any hazard.
For safety reasons, the electronic transformer switches o automatically at a temperature of 80°C and on again aer an appropriate
cooling down phase.
Automatic switcho: thanks to the integrated timer, the spotlights switch o automatically (io-home control technology: aer 6 hours. The
lighting can be reactivated by double-clicking either the switch or the remote control.
The radiation intensity of these LED lamps is harmless to people and underruns the RG 2 area acc. EN 62471. However, it is suggested not to
look for a long time at the centre of the light source.
markilux markant
Operation manual
markilux.com
To Next Page
Loading...
