Markilux Markant - Channel Assignment and Modifications; Channel Assignment for io-5 Designcontrol; Conversion or Retrofitting

8
205
125
SAM M
MA
SAM H
MA
280 410
□125
GH
AH
=
=
rear
front
le
right
Preset channel assignment for 2-field unit
Hand-held
control
CHANNEL Configuration options
1
1 Awning motor le
2 Awning motor right
3 Lighting frame
4 Lighting front gutter
5 Vertical cassette awning le
2
1 (6) Vertical cassette awning rear
2 (7) Vertical cassette awning right
3 (8) Vertical cassette awning front
4 (9) Infrared heater rear le*
5 (10) Infrared hearer rear right*
3
1 (11) Infrared heater front le*
2 (12) Infrared heater front right*
3 (13)
4 (14)
5 (15)
Preset channel assignment for 1-field unit
Hand-held
control
CHANNEL Configuration options
1
1 Awning motor
2 Lighting frame
3 Lighting front gutter
4 Vertical cassette awning le
5 Vertical cassette awning rear
2
1 (6) Vertical cassette awning right
2 (7) Vertical cassette awning front
3 (8) Infrared heater rear*
4 (9) Infrared heater front*
5 (10)
* = Infrared heaters are not configured in the factory.
The following modifications can be carried out retrospectively on your awning by your markilux specialist.
• Replacement of the awning cover
• Installation of a motor
• Retrofitting an automatic control system. In principle a motor drive must be available. Ask your specialist dealer about sun and wind
sensors, remote control, Vibrabox etc.
2.2 Channel assignment of the handheld radio transmitter markilux io-5 designcontrol
3 Conversion or retrofitting
markilux markant
markilux.com
Operation manual