10
6 Troubleshooting
* In this situation, also pay attention to the display on the Central Station at Setup, Information!
Description of Malfunction Possible Causes Correction of Malfunction
The Booster is not providing any
power. The housing is cold.
The LED does not light up.
The power pack is not plugged in. Plug in the switched mode power pack.
The plug connections for the wire bet-
ween the Booster and the transformer
are bad/damaged.
Check the connection and repair.
The switched mode power pack has
shut off due to overheating.
Wait until the switched mode power pack has
cooled off and then turn it on again.
The Booster is not correctly con-
nected.
Check the connections from the Boosters to the
Central Station / to the Terminal and to the track.
Short circuit in the track. Correct the short circuit and press the STOP
button.
The Central Station is registering
an overload, but there is no short
circuit.
The Booster is connected to a
switched mode power pack that is too
weak for it. *
Replace the switched mode power pack with a
more powerful unit.
The Booster is providing no po-
wer. The housing is warm to the
touch. The LED is lighting up red.
The unit is overheated. * Let the Booster cool down and then try opera-
ting it again.
The Booster shuts off often. The Booster is overloaded. * Reduce the power consumption area for the
Booster / the number of power consumption
users. If necessary, mount the Booster in a
better ventilated location.
The Booster shuts off. The Booster is connected to a
switched mode power pack that is too
weak for it.
Replace the switched mode power pack with a
more powerful unit.
Too little power. The Booster is connected to a
switched mode power pack that is too
weak for it.
Replace the switched mode power pack with a
more powerful unit.
To Next Page
Loading...