3
Safety Notes
• Use only switched mode power supply units that are designed for your local power
system.
• This set must never be supplied with power from more than one power pack.
(DC 18V / max. 36VA)
• On large gauge railroads such as LGB and Märklin 1 Gauge, please note the permissible
current load of 1.9 amps!
General Notes
• When you find the following symbol in a section, the menu point described is only impor-
tant for this digital protocol.
= only for Märklin Motorola (MM)/mfx
= only for DCC
• These instructions for operation refer to the Mobile Station 2 (MS2) starting with Soft-
ware Version 3.55. It may be necessary to update your MS2. Update instructions can be
found on the Internet at www.maerklin.de --> Service --> Technical Information.
• The operating instructions are a component part of the product and must therefore be
kept in a safe place as well as included with the product, if the latter is given to someone
else.
Spare parts
Control knob red E146 711
Control knob green E153 427
Feet E159 844
Cable with plug E146 781
To Next Page
Loading...
