14
Turn On the Ignition
3 long chirps and 3 flashes of the parking lights will confirm exit of the
programming mode.
Note: Waiting 15 seconds after the last command will also cause the
system to automatically exit the programming mode.
One Chirp Two Chirps Three Chirps Four Chirps
Button LED One Pulse LED Two Pulse LED Three Pulse LED Four Pulse
(Factory Default Setting)
Step 4
Alarm Feature Programming (Part 1)
Examine the 3 different feature charts enclosed and decide which feature will get changed. Circling the feature to
be changed will make the programming process much easier to perform.
Turn the ignition switch from the OFF position to the
ON position 3 times leaving it in the OFF position the
third time.
Before 15 seconds has passed, push and release the
valet switch 1 time then push the valet switch a second
time and hold it in on until 1 short and 1 long chirp or
beep is heard then release it. You
are now in transmitter
part 1 programming mode
.
Step 1 Step 2
3X
1X + 1X (Hold)
Step 3
Remote Feature Programming
Use the transmitter buttons as illustrated to adjust the features required. Keep re-pressing the transmitter button
that relates to the feature you want to adjust until the correct amount of chirp/beeps is heard. Move on to the next
feature.
All Chirps Siren Chirp On Only Horn Chirp On Only All Chirps Off
Passive Arming without
Passive Door Locking
Passive Arming
Passive Door Locking
Active Arming
Automatic Rearm On Automatic Rearm Off
With Door Ajar
Error Chirp
30 Second Delay
Door Ajar Warning
M7A-IM 6/22/06 4:53 PM Page 14
To Next Page
Loading...
