EN
49
SNOOZE MODE
• When the alarm signal goes on, tap the
"A" button to temporarily switch o the
alarm signal and to activate snooze mode.
After the set time for snooze mode the
alarm will be set o again. Snooze mode
can be repeated.
• Press any button except "A" to switch o
snooze mode, or press the "A" button for
3 seconds.
VALUES FOR TEMPERATURE/
HUMIDITY AND HISTORY/TREND
• Tap the "D" button to show high/low
value for temperature, humidity,
experienced temperature, dew point,
temperature index and wind-chill index.
• When high/low temperature or humidity
are shown, tap the "G" button to switch to
display data from other channels.
NOTE:
Experienced temperature, dew point,
temperature index and wind-chill index
are derived from the value detected by the
multifunctional wireless remote sensor.
• When showing the history for
temperature/humidity, press the "D"
button for 3 seconds to clear all the
history for the wireless remote sensor for
temperature/humidity.
NOTE:
• The values for the wireless remote
sensor for temperature/humidity are
reset to the current values.
• The display mode closes after 20
seconds if no buttons are pressed, or
when the "A" button is pressed.
• Trends can be shown for the values from
the wireless remote sensor for
temperature/humidity.
3. Tap the "C" button to conrm and go to
the next item.
NOTE:
The settings mode closes after 20 seconds
if no buttons are pressed, or when the "A"
button is pressed.
SETTINGS SEQUENCE
1. Hours alarm 1
2. Minutes alarm 1
3. Repetition alarm 1: M-F/S-S/M-S
4. Snooze time alarm 1: 5 to 60 minutes/OFF
5. Hours alarm 2
6. Minutes alarm 2
7. Repetition alarm 2: M-F/S-S/M-S
8. Snooze time alarm 2: 5 to 60 minutes/
OFF
NOTE:
• If alarm repetition is set to M-F the
alarm is repeated Monday to Friday, but
not Saturday and Sunday. If alarm
repetition is set to S-S the alarm is
repeated Saturday and Sunday, but not
Monday to Friday. If alarm repetition is
set to both M-F and S-S the alarm is
repeated all the days of the week.
• The snooze mode can be set from 5 to
60 minutes, or set to OFF (deactivated).
• The alarm will continue for 1 minute if it
is not deactivated by pressing a button.
In which case the alarm will repeat
automatically after 24 hours.
• Ascending alarm signal (duration 2
minutes): The volume changes 4 times
during the duration of the alarm signal.
SWITCHING OFF THE ALARM
Press any button except "A" to switch o the alarm
signal, or press the "A" button for 3 seconds.
To Next Page
Loading...
