39
– Press twice for TRE (treble)
– Press three times for BAL, allowing you to adjust the balance between right/left speakers
– Press a fourth time to enter fader mode, allowing you to set the balance between front
and rear speakers
– Press a fth time for volume adjustment (VOL)
Keep the button pressed and then press it to adjust the following settings:
– Keep pressed to display LOUD (loudness on/o)
– Press once for DSP mode and turn to switch between POP, ROCK, CLASS and FLAT
categories.
– Press a second time for DX, turn the knob to switch to LOCAL (front panel/remote control)
– Press a third time for STEREO, turn to select MONO
– Press a fourth time for TA. SEEK, turn to show TA. ALARM
– Press a fth time for PI SOUND, turn to select PI MUTE
– Press a sixth time for RETURN L, where you can select ANS setting. PI 90 seconds
automatic scanning. Turn for RETURN S - 30 seconds automatic scanning.
– Press a seventh time for BEEP OFF, turn to select BEEP ON.
9. PTY: press to select function in ANS mode
Press PTY once, ”MUSIC” will appear in the LCD screen.
– Press the number button (1) to bring POP M up in the display, press once more for
ROCK. M
– Press the number button (2) once to bring EASY M up in the display, press once more for
LIGHT M
– Press the number button (3) once to bring CLASSICS up in the display, press once more
for OTHER M
– Press the number button (4) to bring JAZZ M up in the display, press once more for
COUNTRY
– Press the number button (5) once to bring NATION M up in the display, press once more
for OLDIES
– Press the number button (6) once to bring FOLK M up in the display
To Next Page
Loading...