Problem: The punches are not cutting completely through the oilboard.
Possible Cause:
1. The punches are clogged with oilboard particles.
2. The punch depth adjustment may need to be
increased.
3. If cleaning the punches with the cleaning hook and
adjusting the punch depth does not improve the
cutting of the characters, the punch and die need to
be replaced.
Problem: The lower feed rollers are not griping the oilboard.
Possible Cause:
1. The left lower feed roller is catching or not moving
smoothly because of wear.
Solution:
1. Clean the punches with the cleaning hook. See page
11.
2. The punch depth adjustment is preset at the factory.
Only adjust the punch depth if the punches are not
cutting properly after being cleaned with the
cleaning hook. To adjust the punch depth, see page
25.
3. Replace the punch and die that is not cutting
properly. See page 27.
Solution:
1. Replace the lower feed roller assembly. See page 29.
Troubleshooting
15
25004/98337 Rev C
To Next Page
Loading...
