Index
52
25004/98337 Rev C
A
Adjusting
tracking on lower feed rollers 23
adjusting the punch depth 25
C
Cleaning
the punches 11
the treads on the left feed wheel 21
crooked characters 14
Cutting the oil board 9
H
Hand stencil machines, varieties 3
I
Inks 3
Inserting the oil board 7
Installation 5
Introduction 3
M
Maintenance 11
cleaning the punches 11
oiling the machine 13
O
Oilboard:
types to use 7
inserting the oilboard 7
movement through the machine 14
Oiling the machine 13
Operation 7
inserting the oilboard 7
cutting the oilboard 9
P
Parts List 32
Punch and die
cleaning 11
replacing 27
punch depth 15
punch depth, adjusting 25
R
Repair 21
Replacing:
the lower feed roller assembly 29
a punch and die 27
S
Slanted characters 14
Spacing of characters 14
Stencil board
inserting stencil board 7
selecting stencil board 7
T
Table of contents 1
Treads, cleaning 21
Troubleshooting 14
To Next Page
