13
42900 Rev. 09-30-2008
Cleaning the Cutter Assembly – Figure 9
1. Turn the power switch to the OFF position and unplug the power cord.
2. Open top cover.
3. Remove pressure plate.
4. Remove the tape from the tape path.
5. Using generous amount of a non-flammable lubricant (MG Chemicals Super Penetrating
Lubricant [www.mgchemicals.com], is recommended), spray the cutter assembly behind
the cutter guard, using the available gaps in front and behind the cutter guard. Allow the
lubricant to dry or wipe dry.
6. Place the tape back in the tape path, refer to loading tape section.
7. Place the pressure plate back into the machine.
8. Close top cover.
Cleaning the Tape Path – Figure 9
1. Turn the power switch to the OFF position and unplug the power cord.
2. Open the top cover.
3. Remove pressure plate.
4. Remove tape from tape path.
5. Using compressed air remove all debris form the tape path.
6. Using a moist cloth wipe down all sheet metal parts within tape path (tape channel,
pressure plate, weighted brush tank cover, and water tank holder) to remove debris and
adhesive build-up.
7. Using compressed air remove any visible moisture from the tape path.
8. Referring to the tape loading section, place the tape back into the tape path.
9. Place the pressure plate back in the machine.
10. Close the top cover.
To Next Page
Loading...
