To Next PageTo Next Page
Need help?Do you have a question about the Marshall Amplification JCM 2000 DSL201 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Speaker Configuration | 1 x 12" |
| Effects Loop | Yes |
| Tubes | 3 x ECC83 |
| Reverb | Yes |
| EQ | Bass, Middle, Treble |
| Controls | Gain, Volume, Bass, Middle, Treble, Reverb |
| Dimensions | 280 mm |
| Outputs | 1 x 8 Ohm, 1 x 16 Ohm |
Essential safety precautions for using the amplifier to prevent hazards.
Details the JCM2000 DSL201/DSL401 combos, their design, and intended use.
Connecting your guitar and adjusting the clean channel's gain.
Using Treble, Mid, and Bass controls for the clean tone.
Switching channels and setting overdrive gain for tone.
Balancing overdrive volume and shaping its tone with EQ.
Overview of master volume, FX mix, reverb, standby, and power switches.
Details on footswitch, reverb, and FX loop connection points.
Connecting speakers, selecting impedance, and using the DI output.
Fuse protection, mains connection, and loudspeaker system compatibility.
Key technical data for the DSL201 amplifier model.
Visual guides to the DSL201's front and rear panel components.
Key technical data for the DSL401 amplifier model.
Visual guides to the DSL401's front and rear panel components.
