Need help?Do you have a question about the Marshall Amplification JMD100 and is the answer not in the manual?
Covers speaker connection, volume, mains connection, and electrical supply checks.
Details the correct sequence for powering on, warming up valves, and using standby.
Covers input jack, manual/channel modes, and storing/recalling presets.
Details selecting from 16 pre-amps and adjusting Gain, EQ, and Volume.
Describes the main power switch and the standby switch for warm-up and silent operation.
Explains the function of Gain, Bass, Middle, Treble, Volume, Modulation, and Delay controls.
Explains the Serial/Parallel FX Loop and the various speaker output options.
General| Power Output | 100 Watts |
|---|---|
| Power Tubes | 4 x EL34 |
| MIDI Control | Yes |
| Effects | Reverb, Chorus, Phaser, Flanger, Delay |
| Speaker Outputs | 2 |
| Speaker Configuration | Requires external speaker cabinet |
| Type | Hybrid Guitar Amplifier |
| Channels | 4 (Clean, Crunch, OD1, OD2) |
To Next Page