Need help?Do you have a question about the Marshall Amplification MA100C and is the answer not in the manual?
General| Power Output | 100 Watts |
|---|---|
| Reverb | Yes |
| Effects Loop | Yes |
| Type | Guitar Amplifier |
| Channels | 2 (Clean, Overdrive) |
| Tubes | 4 x EL34 (Power Amp) |
| Outputs | 1 x 1/4" Speaker Output |
Describes the four MA Series models and mentions spring reverb, FX loop, and footswitch compatibility.
Explains the preamp (ECC83) and power valves (EL34), chassis design, and tone characteristics.
Details the input jack, Bass, Middle, Treble, and Volume for the Clean channel.
Covers the switch for Clean/Overdrive, and LEDs for channel selection and boost status.
Details Crunch Balance, Gain, Bass, Middle, and Treble for the Overdrive channel.
Sets the overall output volume for the Overdrive channel.
Controls for Reverb, Resonance, and Presence for overall tone shaping.
Details the function of the Standby and Power switches for amplifier warm-up and operation.
Guidance on balancing gain, volume, and EQ controls for achieving desired tones.
Details the 8 Ohm and 16 Ohm speaker output jack configurations for cabinet connection.
Connects the supplied two-way footswitch for remote channel and boost control.
Allows connection of external effects processors to enhance sound.
Connection point for the mains power lead and integrated fuse holder.
To Next Page