Need help?Do you have a question about the Marshall Amplification MG15 GFX and is the answer not in the manual?
General| Power Output | 15 Watts |
|---|---|
| Speaker Size | 8 inches |
| Speaker | 1x8" |
| Effects | Digital Effects |
| EQ Controls | 3-band EQ |
| Controls | Gain, Volume |
| Inputs | 1 x Instrument Input |
| Outputs | 1 x Headphone Output |
| Type | Solid State |
Ensure amplifier compatibility with mains supply and seek professional advice if unsure.
Step-by-step guide for safe initial amplifier setup, including power and volume settings.
Input for connecting your guitar. Use a screened/shielded cable to prevent noise.
Connect headphones for silent practice; mutes the internal speaker.
Turns the amplifier on and off. Channel switch indicates power status.
Matches delay time or switches between Manual/Preset modes.
Connect headphones for silent practice; mutes the internal speaker.
Connect your guitar here using a screened/shielded cable to prevent noise.
Controls the pre-amp signal level and distortion amount.
Adds digital reverb (Studio/Spring) to channels.
Selects and adjusts digital effects like Chorus, Phaser, Flanger, Vibe, Octave.
Stores amp settings into a channel or recalls them.
Turns the amplifier on and off. Channel switch indicates status.
Details how to switch between Clean, Crunch, OD-1, and OD-2 channels.
Explains the two operating modes: Preset and Manual, and how to switch between them.
Procedure to restore factory settings, warning about loss of user data.
Explains how each footswitch can be assigned a different stored function.
Explains how to program footswitches for switches or presets.
How to assign a front panel switch to a footswitch location.
How to assign a preset to a footswitch.
To Next Page