To Next PageTo Next Page
Need help?Do you have a question about the Marshall Amplification Valvestate 2000 AVT series and is the answer not in the manual?
General| Type | Guitar Amplifier |
|---|---|
| Channels | 2 |
| Preamp Tubes | 1 x 12AX7 / ECC83 |
| Effects | Reverb |
| EQ | 3-Band (Bass, Middle, Treble) |
| Technology | Hybrid (Valve and Solid State) |
Crucial safety instruction mandating the earthing of the apparatus for protection.
Warning against unauthorized modifications that could void user authority.
Recommendation for using high-quality, screened audio cables not exceeding 10 metres.
Instruction to ensure free movement of air around the amplifier by not obstructing grilles.
Guidance on not defeating the purpose of polarized or grounding plugs for safety.
Explanation of Advanced Valvestate Technology (AVT) as a hybrid amplifier design.
Description of the ECC83 valve in the preamp stage and its sonic benefits.
Focus on the power stages designed for warm, musical feel and live performance reliability.
Details on developed speakers providing strong bottom end in compact cabinets.
Description of integrated Digital Effects (DFX) and their impact on signal integrity.
Details the preamp section where gain, tone, and volume of channels are set.
The primary input for connecting your guitar to the amplifier.
Allows selection of the Clean channel from the front panel.
Regulates drive into preamp valve stages for clean to crunch tones.
Adds high frequencies to the Clean channel drive for brighter tones.
Determines the volume of the clean channel, with potential for power amp distortion.
Rotary Bass, Middle, and Treble controls for maximum tonal variation.
Switch to select the Overdrive 1 (OD1) channel of the amplifier.
Controls the 'sonic brain' of the OD1 channel for various overdrive tones.
Provides a pre-set mid-scoop contour for the OD1 channel.
Determines the output volume of the OD1 channel.
Switch to select the Overdrive 2 (OD2) channel of the amplifier.
Provides extreme gain levels for a crushing crunch, perfect for modern metal.
Advanced contour control for OD2, creating a 'bottom heavy' scooped sound.
Regulates the drive of the OD2 channel into the power stage, controlling its volume.
Shared Bass, Middle, Treble EQ for OD1 and OD2, similar to classic Marshall amps.
Controls that adjust the power amp section, determining overall volume and presence.
Governs the overall volume of the amplifier after channel volumes are set.
Increases high frequency control by altering power amplifier feedback.
Details the effects section, including parallel FX loop and internal digital effects.
Rear-mounted parallel FX loop for connecting external effects devices.
Adjusts the mix of external effects for all channels, from dry to wet.
Features 16 on-board digital effects with controls for Mix, Adjust, and Program.
Descriptions of the 16 available DFX programs, including reverbs, chorus, and delay.
Determines the level of the internal digital effects.
Adjusts a specific parameter for each DFX program, like decay or rate.
Selects each of the 16 on-board digital effects programs.
Table listing programs and the parameter adjusted by the Adjust control.
Switches the amplifier on and off, with indicator light and anti-thump circuitry.
Connection point for the detachable mains (power) lead.
Socket for connecting the internal 8 Ohm Celestion loudspeaker.
Critical warning to always provide a load equal to or greater than 8 Ohms.
Connection for the supplied 4-way footswitch for channel and DFX selection.
Emulated headphone output for silent practice.
Specially treated output emulating a Marshall 4x12 cabinet for recording/live use.
Details the FX Send, FX Return, and FX Level controls for external effects.
Tips for using the parallel FX loop effectively with various effects.
