14
RS422 (VISCA) connection
1. Set Bottom DIP Switch SW1-B6 to OFF. (See page 16).
2. Set Baud Rate on Bottom Dip Switch to the same as Baud Rate setting on the keyboard you are using.
(See page 16).
3. Reboot the camera by turning it Off/On after the Bottom Dip Switch has been set up correctly.
4. Does not need setting camera address in way of RS422(VISCA) controlling.
5.
The controller must be VISCA compatible.
6. Camera supports Daisy Chain connection up to 7 cameras.
7. The connection of SONY keyboard is different than other VISCA (None-Sony) keyboard.
SONY Keyboard RS422 Connection
VISCA (None-Sony) Keyboard RS422 Connection
PELCO P/D Keyboard RS485 Connection
1. Use PELCO P/D compatible keyboard.
2.
Use preset 95# on the keyboard to bring up/exit camera OSD menu.
3.
Use joystick and Button “OPEN” or “CLOSE” to navigate OSD menu.
4.
To operate keyboard, please refer to the user manual of the keyboard you are using.
Note
For RS-232 VISCA control, this unit does not support daisy chain connection for using multiple cameras.
For control details, please refer to Operating Instructions of control keyboard/station software.
You need to match the communication speed between the camera and the joystick controller.
You can use the RS-232 connections when using the RS422/485 connection.
The specified frame rate may change when communicating via a USB3.0 hub.
To Next Page
Loading...
