46
RTD_TYPE
Sets the RTD type. The following is a list of RTD types they way they should be entered after
the command:
PT385_10; PT385_50; PT385_100; PT385_200; PT385_500;
PT385_1000; PT392_100; PTJIS_100; Ni120; Cu10; Cu50;
Cu100; YSI_400; OHMS; CUSTOM;
For example:
RTD_TYPE PT385_10 sets RTD type to Pt385-10
RTD_TYPE?
Returns the RTD type.
RTD_WIRE
Sets the number of wires used for connection in measuring RTDs. The calibrator measures
RTDs using 2-, 3-, and 4-wire connections. After the command, enter 2W for 2- wire, 3W for 3-
wire, and 4W for 4-wire. For example:
RTD_WIRE 4W sets the connection to 4-wire
RTD_WIRE?
Returns the number of wires used in the RTD connection.
SIM
Sets the output for current simulation. This command also switches the calibrator into mA
simulation mode. A number and a unit must be entered after the command. For example:
SIM 5 MA sets the current simulation at 5 mA
SIM?
Returns the output of the current simulation. With the example above, the output would be:
5.000000E-03, A
ST_CLOSE?
Returns the value that the switch closed at in the current units.
ST_DEAD?
Returns deadband of the switch in the current units.
ST_OPEN?
Returns the value that the switch opened at in the current units.
To Next Page
Loading...