Martin M6 Series - Setting Jumper J_ATXCTL1 Procedure; Power Off and Disconnect; Open Controller Back Cover; Remove Cover Plate

www.martin.com • Olof Palmes Allé 18 • DK-8200 Aarhus N • Denmark
Tel. (+45) 8740 0000 • Fax (+45) 8740 0010
Setting jumper J_ATXCTL1
1. Switch the controller OFF and
disconnect the power cable from the
controller.
2. Open the right back cover of the
controller (seen from the back of the
controller): unscrew 5 screws (Use a
torx T-10)
3. Slide the cover plate from the
controller