Martin M6 Series User Manual

M6™ Controller
Power cycle reliability improvement
Symptom
In some M6
TM
controllers, the mainboard may not start-up while all other parts of the controller
are powered-up normally.
Solution
Jumper J_ATXCTL1 must be set from position 1-2 to position 2-3.
Anti-Static Precautions
Important! Static electricity can destroy electronic
components. Follow these ESD precautions to prevent damage
to the product and injury to the user.
Carry out the service at an anti-static workstation.
Wear a grounded anti-static wristband.
Touch a grounded conductor every few minutes to discharge any
static buildup.
Hold components by their edges only. Do not touch the surfaces or
any of the contacts of the PCBs.

Martin M6 Series Specifications

General

Brand	Martin
Model	M6 Series
Category	Controller
Language	English

Summary

M6 Controller Reliability Improvement

Symptom of Mainboard Startup Failure

Mainboard may not start-up while other controller parts power up normally.

Jumper Setting Solution

Jumper J_ATXCTL1 must be set from position 1-2 to position 2-3.

Anti-Static Precautions

Essential ESD precautions to prevent component damage and user injury.

Setting Jumper J_ATXCTL1 Procedure

Power Off and Disconnect

Switch the controller OFF and disconnect the power cable.

Open Controller Back Cover

Unscrew 5 screws to open the right back cover.

Remove Cover Plate

Slide the cover plate from the controller.

Locate Jumper J_ATXCTL1

Identify Jumper J_ATXCTL1 on the mainboard.

Adjust Jumper Position

Set the jumper from position 1-2 to position 2-3.

Connect Power and Power On

Connect power, switch ON, and press power-on switch if needed.

Verify and Finalize

Wait for menu, power off, power on again, then close controller.