www.martin.com • Olof Palmes Allé 18 • DK-8200 Aarhus N • Denmark
Tel. (+45) 8740 0000 • Fax (+45) 8740 0010
5. Jumper is in position 1-2. Set
jumper to position 2-3.
6. Connect power to the controller
and switch ON.
7. If the mainboard doesn’t power up,
press the power-on switch on the
mainboard (to the right of the
jumper).
8. Wait until the menu appears on the
screen, and power-off (mains
switch on the front).
9. Power-on again (mains switch on
the front). The mainboard should
now start automatically.
10. Power-off again and close the
controller.
To Previous Page
Loading...
