22 3
CONTENTS
1 Introduction
1.1 Description
1.2 Earth Continuity
1.3 Fuse Rating
1.4 Insulation
1.5 Run (Load)
1.6 Earth Leakage
1.7 Flash
1.8 Unpacking & Inspection
1.9 Accessories
2 Specifications
2.1 Technical Specification
2.2 Mechanical Specification
2.3 Environmental Specification
3 Operation
3.1 Start Up
3.2 Set Up Mode
3.3 Outputting Stored Records
3.4 Testing Appliances
3.4.1 Manual Mode
3.4.2 Auto Mode
3.4.3 Appliance & User I.D.
3.4.4 PROCEED and MAN Keys
3.5 110/240V Operation
3.6 Battery Backup
3.7 Table of Codes for Test Parameters
4 Maintenance
4.1 Cleaning
4.2 Calibration
4.3 Repair & Service
4.4 Storage Conditions
5 Maintenance
4. MAINTENANCE
4.1 Cleaning
The exterior of the instrument can be cleaned with a dry clean cloth to remove
any oil, grease or grime. Never use liquid solvents or detergents.
4.2 Calibration
The recommended calibration interval is 12 months.
Martindale Electric will carry out routine calibration (on a chargeable basis) if the
instrument is returned, carriage paid, to the address on the final page of this
document. Alternatively, a chargeable collection and return service is available.
4.3 Repair & Service
Repairs or servicing not covered in this manual should only be performed by
qualified personnel. There are no user serviceable parts in this unit. Return to
Martindale Electric Company Ltd if faulty, unless fuse replacement only is
necessary. Our service department will promptly quote to repair any faults that
occur outside the warranty period.
4.4 Storage Conditions
The MicroPat+ should be kept in warm, dry conditions away from direct sources
of heat or sunlight and in such a manner as to preserve the working life of the
instrument.
To Next Page
Loading...
