MartinLogan Motion 60XT - Technical Specifications

11
sPeCiFiCAtions*
Frequency Response .....................
Dispersion ............................
Sensitivity.............................
Impedance ............................
Crossover Frequency.....................
High Frequency Driver ...................
Mid Frequency Driver ....................
Low Frequency Drivers ...................
Cabinet ..............................
Components ...........................
Recommended Amp Power ................
Binding Post Inputs ......................
Weight...............................
Dimensions (HxWxD) ....................
35–25,000Hz±3dB
80° x 30°
94 dB @ 2.83 volts/ meter
4 Ohms. Compatible with 4, 6 or 8 Ohm rated
amplifiers.
400&2,200Hz
1.25” x 2.4” (3.2cm x 6.1cm) Folded Motion
Transducer with 4.5” x 2.75” (11.4cm x 7cm)
diaphragm.
6.5” (16.5cm) aluminum cone with cast polymer
basket.Sealedchamberformat.Rigidstructured
dust cap to reduce cone break-up modes.
Two 8” (20.3cm) aluminum cone with cast alumi-
num basket. Non-resonant asymmetrical chamber
format.Rigidstructureddustcaptoreducecone
break-up modes.
Ported
CustomaircorecoilandlowDCRsteellaminate
inductors. Polypropylene film capacitors in series
andlowDFelectrolyticcapacitorsinparallel.
Tweeter thermal/current protection.
20–400 watts
Custom 5-way bi-wire tool-less binding posts
66 lbs. (30 kg)
48” x 11.4” x 14.4”
(121.8cm x 29cm x 36.6cm)
*Specifications are subject to change without notice.