— 11 —
English
OPERATING INSTRUCTIONS
STARTING PROCEDURE
PRIMER
BULB
FUEL
RETURN LINE
CHOKE
LEVER
CLOSE
OPEN
STARTER GRIP
1/2 SPEED
STOP
START
➮
➮
STEP #1)
Pump the "PRIMER BULB" under of the
carburetor until fuel can be seen flowing
through the "FUEL-RETURN LINE".
STEP #2)
Move the "CHOKE LEVER" fully up ward to
the closed position. If the engine is already
warm, only a partial or open (no choke) choke
setting may be required.
STEP #3)
Turn the stop switch ON. (Confirm that the
stop switch is at the starting position.)
Set the throttle lever at 1/2 speed.
STEP #3)
Set the throttle lever at 1/2 speed.
HA Type Standard
HIGH SPEED
IDLE SPEED
STOP
CAUTION!
Press down the "AIR FILTER COVER" and Pull the
"STARTER GRIP" briskly to start the engine.
NOTE: Only short pulls are necessary. Never pull the
starter cord to its fullest extension. Never let go of the
To Next Page
Loading...
