11
OPERATING INSTRUCTIONS
STARTING PROCEDURE
STEP #3)
Set the LEVER at 1/2 speed.
If a MARUYAMA engine fails to start after following the above procedures, contact an authorized MARUYAMA dealer.
STEP #1)
Pump the "PRIMER BULB" under of the carburetor until
fuel can be seen flowing through the "FUEL-RETURN
LINE".
STEP #2)
Move the "CHOKE LEVER" fully upward to the closed
position. If the engine is already warm, only a partial or open
(no choke) choke setting may be required.
CHOKE
LEVER
OPEN
OPEN
CLOSE
CHOKE
LEVER
IDLE SPEED
HIGH SPEED
LEVER
STEP #4)
Press down the "AIR FILTER COVER" and hold the
"FRAME" with your right foot gently.
Pull the "STARTER GRIP" briskly to start the engine.
NOTE: Only short pulls are necessary. Never pull the
starter cord to its fullest extension. Never let go of the
starter grip until it is at the fully returned position.
STEP #5)
Warming up the engine.
When the engine has started, slowly move the
"CHOKE LEVER" fully downward to the open position.
To Next Page
Loading...
