To Next PageTo Next Page
Need help?Do you have a question about the Maruyama MC260 and is the answer not in the manual?
Connects the shaft and clutch drum housing to the engine unit.
Procedure for attaching the loop handle to the shaft.
Installation of throttle cable and stop-switch wires.
Installing the blade guard onto the shaft with screws.
Installing the trimmer head for LEFT-HAND rotation.
Information on using and installing optional metal cutting blades.
Attaching the string guard and cutter blade with screws.
Installing the trimmer head for RIGHT-HAND rotation.
Warning about the sharpness and danger of hedge trimmer blades.
Installing the blade guard assembly onto the gearcase.
Instructions for correctly mixing gasoline and two-cycle oil for the engine.
A chart showing oil-to-gasoline ratios for different oil types.
Step-by-step guide for starting the multi-cutter engine.
Guidance on warming up the engine and operating under load.
How to stop the engine using the stop-switch or primer-bulb.
Adjusting the engine's idle speed using the adjustment screw.
Adjusting handles and positioning safety guards for proper operation.
Techniques for effective cutting with nylon trimmer line.
Warnings and precautions when using metal cutting blades.
Methods to avoid dangerous kick-back when cutting heavy brush.
Checking blade adjustment and lubrication before hedge trimming.
How to hold and operate the hedge trimmer for best results.
Adjusting the cutting depth using the blade guard.
Operating the edger from the right side of the operator.
Procedure for cleaning and maintaining the air filter.
Checking, cleaning, and adjusting the spark plug gap.
Ensuring clear passage of air through cooling fins for engine health.
Inspecting the fuel filter for dirt/damage and replacing it.
Procedure for inspecting and cleaning the spark arrestor.
Steps for inspecting and cleaning the exhaust muffler.
Lubricating the gearcase for MC260S models.
Lubricating the gearcase for MC260E models.
Lubricating gearcase and angle drive for MC260D models.
Lubricating the flexible driveshaft for MC260C and MC260E models.
Adjusting blade tension to prevent vibration and ensure proper cutting.
Maintaining the machine through regular cleaning and tightening.
Steps for preparing the multi-cutter for long-term storage.
Details of the product warranty, coverage, and exclusions.
Address and contact details for Maruyama U.S., Inc.
General
