Use of brake and parking method
Rotate the accelerator grip outward to fully close the throttle.
At the same time, apply the front and rear brakes with even forces.
Use gear shifting to slow down.
Before the motorcycle is stopped, firmly press the clutch grip, shift into
neutral gear and observe the neutral indicator to make sure the neutral gear is
engaged.
An inexperienced driver always uses the rear brake only. This will cause
premature wearing and too long a braking distance.
It is dangerous to use front brake or rear brake only. This may cause
slipping and out of control. On wet highway or other dull road surface and
during turning, be extremely careful to apply the brake gently. Hard braking on
rough or dull road surface is very dangerous.
The motorcycle shall be parked on stable and flat ground.
To park your motorcycle on a gentle slope by using the side stand,
engage the first gear to prevent sliding off the side stand. Remember to shift
to neutral gear before starting the engine.
Turn the ignition switch to OFF position to shutdown the engine.
Remove the key from ignition switch.
Lock the steering bar for safety.
Warning
The faster the vehicle is driven, the longer the braking distance will be.
Be sure to make correct estimation of the distance between you and the
vehicle or object in front of you for adequate braking performance.
To Next Page
Loading...
