3. Remove drain plug from strainer cover on the engine bottom to drain oil.
4. Tighten the oil drain ring and fill fresh engine oil into the oil filler, before
gently tightening the top cover.
Note :
Always check the oil level to make sure the oil quantity is correct.
5. Start the engine and allow it running idle speed for several seconds.
6. Stop the engine and wait about one minute before checking the fluid
level with the oil dipstick. The level must reach the upper mark
(maximum). If the level is below this benchmark,
give the change.
Warning
Please use the engine oil recommended in "Instructions on fuel and
engine oil".
To Next Page
Loading...
