Troubleshooting
PROBLEM PROBABLE CAUSE REMEDY SUGGESTED
Fails to split logs
Log is improperly positioned.
Refer to ‘Log Splitter Operation’ section for
perfect log loading.
The sizes or hardness of the log exceeds capacity
of the machine.
Reduce the log sizes before splitting it on the log
the splitter.
Wedge cutting edge is blunt
Refer to ‘Sharpening Wedge’ section to sharpen
cutting wedge.
Oil leaks Locate leak(s) and contact the dealer.
Unauthorised adjustment was made on Max.
Pressure Limiting Screw.
Lower max pressure rating was set.
Contact the dealer.
The log pusher moves jerkily,
making unfamiliar noises and
vibrations
Lack of hydraulic oil and excessive air in the
hydraulic system.
Check oil level for possible oil refilling.
Contact the dealer.
Oil leaks around log splitter or
from other points.
Air sealed In hydraulic system while operating
Loosen Bleed Screw by 3 - 4 rotations before
operating the log splitter.
Bleed Screw was not tightened before moving
cylinder ram or from the log splitter.
Tighten the Bleed Screw up before moving.
Oil Drain Bolt with Dipstick is not tight. Tighten the Oil Drain Bolt with Dipstick.
Hydraulic Control Valve Assembly and / or seal(s)
worn.
Contact the dealer.
Specifications
Model Number LS4T-52 LS5T-52
Motor - All 230V~ 50Hz 1500W IP54
Log Capacity
Diameter * 5 ~ 25cm
Length 52cm 52cm
Splitting Force 4t 5t
Hydraulic Pressure 16Mpa 20Mpa
Hydraulic Oil Capacity 3.5L 2.4L
Overall Size
Length 940mm 1200mm
Width 270mm 260mm
Height 510mm 485mm
Weight 42kg 50kg
* The diameter of the log is indicative— a small log can be difficult to split when it has knobs or a particularly tough fibre. On the
other hand, it may not be difficult to split logs with regular fibres even if its diameter exceeds the max. figure indicated above.
To Next Page
Loading...
Need help?
General
