MASSEY FERGUSON 2800 Series - Clutch;Brake and Neutral Adjustment

Adjustments
Figure 24. Clutch/Brake Adjustment
CLUTCH/BRAKE ADJUSTMENT
See Figure 24.
1. Engage the parking parking brake. Adjust jam nuts
(H) on end of foot brake rod to provide 1/2” (12.7
mm) spring length between washers.
2. Depress the pedal to engage the brake. The drive
belt should be slack and free of idler pulley. If not,
perform step 3. Test operate the tractor. If brake does
not stop the tractor, see your dealer.
3. To adjust tractor clutch, adjust jam nuts (J) on clutch
rod so there is 1/2” (12.7 mm) spring iength between
washers with clutch/brake pedai in up position.
NEUTRAL ADJUSTMENT
See Figure 25.
If tractor creeps forward or back when ground speed
control lever is in neutral, adjust as follows:
1. Park tractor on level ground. Make sure ground
speed control lever is firmly seated in the neutral
gate. Stop engine and set parking brake. 2.
Raise the seat deck and check if the pump control
arm roller (E) is exactly centered with the centering
mark (D). If not, loosen bolt (C) and move the control
cam (B) until centering mark (D) is centered on roller
(E). Tighten the bolt (C).
3. Lower the seat deck, get in operator’s seat, start
engine and release parking brake. If tractor still
Figure 25. Neutral Adjustment
A. Control Strap F. Pump Control Arm
B. Control Cam Assy. G. Cam Pivot Shaft
C. Bolt H. Jam Nut
D. Centering Mark 1. Adjusting Nut
E. Pump Control Arm
Roller
25