When locking the bolts or nuts with a tab lock washer, bend the tab against the hex, to give secure
locking.
When locking bolts and nuts with an adhesive apply the adhesive on the thread and tighten correctly.
Apply a sealant to parts which have any risk of oil leaks, such as stud bolts and treaded holes.
Tighten each lock nut tight.
See the tightening torque table in introduction section when tightening the bolts and nuts.
Grease fittings
After installation, fill each grease fitting with grease.
When installing 45° or 90° grease fittings, make sure to turn the fitting in a direction that will let easy
access for a grease gun.
Other precautions
Make sure not to damage any finished surfaces or parts.
Always refrain from forcing installation.
Install each lever knob coated with an adhesive.
Coat each contact surface with an adhesive and tighten equally with bolts. Install adhesive coated surfaces
within 30 minutes after application of the adhesive.
The contact surface must be flawless and free from unwanted material. Remove all grease before
application of the adhesive.
Precautions for applying adhesives:
•
The surface or the thread where an adhesive is to be applied must be fully free of chips.
• The surface of the thread where an adhesive is to be applied must be fully free of oil.
1. Introduction
1-22 4608 / 4609 / 4610 Service Manual
4283492M3
To Next Page
Loading...
