Massimo MSU 300 - Page 19

19
gears
3
Steering
organization
Operate flexibly without any
block phenomenon
Fastening bolts on
redirector and steering
transmission organization
which could influence
safety performance
4
Transmission
box
Stepless shift performance
and belt abrasion
5
Tire
Tire pressure and thread
depth
Tire pressure:
F. tire: 148kpa (21PSI)
R. tire: 197kpa (28PSI)
Check front tie-in： 2～
5mm
6
Transmission
organization
Whether the bolts, flange
nuts on transmission shaft
and the bolts on main driver
are tightened.
7
Lamplight
Illumination and signal
Every kind of lamplights,
signal switches and
buttons, etc
8
Battery
Liquid height in storage
cell(except the
maintenance-free battery)
Liquid surface should be
between upper and lower
limit marked, it is
necessary to note only
distilled water could be
filled in storage cell
9
Mwter
Display is normal and correct
10
Dump bed
and
self-saving
winch
Work normally
2、Routine maintenance item table (checked by consumer)