Load regulation: < 0.2%+3mA
Ripple & noise : < 3mArms
3) Display accuracy: ±1%±1 digit
3. Operation Instructions
3-1 Installation
1) Before plugging into AC outlet
Warning: The correct input voltage of the power supply is shown on the AC selector switch, e.g. for 120V
AC, the switch itself should show 110V on the voltage selector switch as shown in picture below:
The AC voltage should be within 10% of that, e.g., if the specified input voltage is 110V, the power
supply will work with AC voltage of 110V±10%.
Warning: Changing the AC voltage selector setting must be done with the power supply unplugged.
Warning: To avoid electrical shock, the power cord ground conductor must be connected to AC ground.
To Next Page
Loading...
Need help?
General
