Charging
Plug in the micro USB
connector and connect to
a USB port to charge.
The headphone turns off
when the micro USB is
plugged in. Avoid using the
device while it is charging
A solid orange light
indicates charging and a
solid green light indicates
a full charge when the USB
cable is connected.
• •
•
Charging Full Charge
TURN ON AND CHARGE
•
•
•
To turn on the MW60 slide the switch
to the middle position.
Each time you turn on the headphone
the battery status will be displayed. To
recall battery status, slide switch to
for less than 2 seconds.
The headphone will automatically
search for previously connected
devices. A solid light indicates you
are connected. If no connection is
made after 1 minute, the headphone
will enter deep-sleep mode. Cycle
power switch to awaken.
Low Battery
ON
Med Battery
Full Battery
Connected