Troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
The fryer is not
operating
Oil is spilling
out of the deep
fryer
1. The control assembly is
not installed correctly.
2. The plug is not con-
nected to the electrical
wall outlet.
3. The electrical outlet is
not energized.
4. The reset switch has
tripped.
1. Too much oil in the oil
reservoir.
2. The food basket is
overfilled.
3. Oil has been used too
often and is foaming.
1. Re-attach the control panel
assembly.
2. Insert the plug into the electrical
wall outlet.
3. Reset circuit breaker or replace
fuse.
cool completely. Then remove
the control panel and press the
thermostat reset button
oil cool completely and remove
some of the excess oil.
2. Remove some of the food from
the
basket.
. Let the oil
cool completely and refill the oil
reservoir with new oil.
Model no. 043-1338-0 | Contact us: 1-855-803-9313
1312
The Reset Feature
Filtering and Changing the Oil
To Filter the Oil:
1. Make sure the oil has cooled (approximately
2 hours) and then empty the oil from the oil
reservoir into another container or bottle. (Fig. 6)
2. Wash and dry the oil reservoir and frying basket.
3. Refill the oil reservoir with the oil by pouring the
oil through a wire strainer or paper filter. (Fig. 7)
To ensure many years of service from your appliance, clean your deep fryer after every use.
1. Never immerse the control panel, cord or plug in water or any other liquid.
2
. Do not place the control panel, cord or plug in the dishwasher.
. Clean the control panel with a damp cloth only.
. The oil reservoir, frying basket can be washed on the top rack of a dishwasher.
. The deep fryer lid can be washed in warm soapy water. Do not put the body of the deep fry
er in
6. To clean the filter, remove it from the cover and wash it in hot
soapy water. Rinse
and dry well before re-inserting it into the deep fryer cover. Replace the filter cover.
,
the liquid or dishwasher.
CAUTION: Do not clean the filter in the dishwasher.
Your deep fryer is equipped with a reset feature. If for some reason the deep fryer stops heating,
check to see if the reset switch has tripped.
To reset the deep fryer:
1. Unplug the appliance from the electrical
wall outlet.
2. Let the appliance and the oil in the oil
reservoir cool completely.
3. After the appliance has cooled completely,
lift the control panel and using the tip
of a ball point pen or pencil, push the
thermostat reset button that is located on
the inside of the control panel. (Fig. 8)
4. Re-assemble the control panel to the
housing of the deep fryer and
resume frying.
Cleaning Instructions
Note: The oil does not need to be changed after each use. In general, the oil will be
tainted rather quickly when frying food containing a lot of protein (such as poultry,
meat or fish). When oil is mainly used to fry potatoes and is filtered after each use,
it can be used 8 to 10 times. However, do not use the same oil for longer than 6
months.
ATTENTION: Make sure the deep fryer is unplugged from the electrical socket and
the oil has cooled (approximately 2 hours) before changing the oil, or cleaning and
storing the deep fryer.
WARNING: Always remove the plug from the electrical wall outlet before cleaning.
Allow the deep fryer and the oil to cool completely (approximately 2 hours) before
cleaning.
DF7705-UL Manual-431338(32开).indd 10-11 2017/3/22 下午 17:57:19
Fig. 6
Fig. 7
Reset button
Fig. 8
,
To Next Page
Loading...
Need help?
General
