11
TM
Lighting Instructions
Step Procedure Illustration
Check the position of thermocouple, make sure
the flame has full contact with the thermocouple.
Note: If thermocouple does not have full contact
with flame, unit will not stay lit.
HOLD the Push
button of safety valve
CAUTION:
If burner does not light OR if burner flame is accidentally extinguished, turn knob to OFF, wait 5
minutes, and try again. If the burner does not ignite with valve open OR if burner flame is accidentally
extinguished after lighting, gas will continue to flow out of the burner and could accidentally ignite
with risk of injury.
7
8
9
10
After burner is lit, continue to HOLD the push
button for 10 seconds and then release.
Holding push button of safety valve for less than
10 seconds will cause burner flame to go out.
If ignition does not occur in 5 seconds, turn the
regulator and LP tank valve o, wait 5 minutes,
and repeat the lighting procedure.
Cycle time for timer is around 15 minutes.
If the timer is not reset within around 15 minutes,
the burner will shut OFF automatically.
If this occurs, please follow lighting instructions
and continue to cook.
To Next Page
Loading...
Need help?
General
