80DO NOT DIVE.
ADJUSTING THE SET TEMPERATURE
When using a panel with Up and Down buttons (Temperature buttons), pressing Up or Down
will cause the temperature to flash. Pressing a temperature button again will adjust the set
temperature in the direction indicated on the button. When the LCD stops flashing, the spa
will heat to the new set temperature when required.
If the panel has a single temperature button, pressing the button will cause the temperature to
flash. Pressing the button again will cause the temperature to change in one direction (e.g. UP).
After allowing the display to stop flashing, pressing the Temperature Button will cause the
temperature to flash and the next press will change the temperature in the opposite direction
(e.g. DOWN).
The temperature can be set between 80˚F and 104˚F.
PRESS-AND-HOLD
If a Temperature button is pressed and held when the temperature is flashing, the temperature
will continue to change until the button is released. If only one temperature button is available
and the limit of the Temperature Range is reached when the button is being held, the progression
will reverse direction.
Spa Controls - MP30
Temperature & Temp Range
To Next Page
Loading...
