Master Water Conditioning MP-MCA-30T - Hardness Setting (the Factory Default Is 10); MP-MCA Control Valve Timer Settings; Regeneration Day Override Setting (the Factory Default Is OFF); Time of Day Setting

12
MP-MCA Control Valve Timer Settings:
Note: The control valve is set at the factory. You only need to set the
time of day , hardness and regeneration time if required, which is preset
at 2 am.
Time of Day Setting
1) Press the CLOCK button. The screen will show the Time of Day
in blinking numbers.
2) To change the Time of Day, use the UP and DOWN arrows to set
the Hour.
3) To change the Minutes, press the CLOCK button, and use the UP
and DOWN arrows to set the Minutes
4) Press the CLOCK button.
Hardness Setting (the factory default is 10)
1) Press the NEXT and UP arrow, hold for 3 seconds. The screen
will show the Hardness as grains per gallon in blinking numbers.
2) To change the number, use the UP or DOWN arrows.
3) Press the NEXT button.
If water was tested by Master Water Conditioning, follow
recommendations on water analysis, for hardness setting
Regeneration Day Override Setting (the factory default is OFF)
1) The screen will show the Regeneration Day Override in blinking
numbers.
2) To change the number, use the UP or DOWN arrows.
3) Press the NEXT button.
Time of Regeneration Setting (the factory default is 2 AM)
1) The screen will show the Time of Regeneration in blinking
numbers.
2) If Regeneration time change is desired, use the UP or DOWN
arrows to set the hour.
3) Press the NEXT button, and use the UP or DOWN arrows to set
the minutes.
4) Press the NEXT button.
NOTE: SALT SETTING AND CAPACITY ARE PRESET AT THE
FACTORY.