EN
EXERCISE COMPUTER INSTRUCTION MANUAL
Over view:
The unit is an electronic that display all workout parameters on LCD display.
The workout parameters include: Odometer (If have), Time, Speed, Distance,
Calories and Pulse (If have). All workout parameters may be selected by the select
key.
Mode or Function
Action
If push the button, the unit will be on and display the
parameters of the last exercise.
Scan
Push the button, the unit will display 5 par
Push the mode key until the “SCAN” signal shows on right
down side. The unit will scan by through Time, Speed,
Distance, Calories and Pulse each for 4 seconds.
Push the mode key again, the scan will stop and the “SCA
signal will disappear. If push the button until the “ODO” points
to “ODO”, the display shows the Odometer on the meter. The
reading of the odometer will be reset to zero after replacing
Push the mode key until the “TMR” points to “T
the exercises time. If the bike stops moving, the unit will stop
When the “SPD” points to “SPD” to display the speed value.
unit: km/h.
When the “DIST” points to “Dist” to display the distance value.
unit: km.
When the “CAL” points to “CAL” to display the calories value.
unit: K Cal.
When the “PULSE” points to “pulse” to display the heart rate of
biker in per minute. If the sensor is contact with ear, clip the
sensor to earlobe before measuring your pulse rate. If the
pulse sensor is contact with hand, place the palms of your
hands on the both of the contact pads before measuring your
pulse rate. If the pulse signal is not in put over 30 second, the
unit will return the “Time” function.
Push the mode key over 3 seconds the showing will become to
The unit will be off if the speed signal stops over 4 minutes.
SPECIFICATIONS:
FUNCTION
4 bit single chip microprocessor
＋
To Next Page
Loading...
