3
CALIFORNIA PROPOSITION 65
This product contains chemicals known to the State of California to cause cancer, birth defects or
other reproductive harm.
WARNING
ASSEMBLY INSTRUCTIONS
Step 2
Insert inner pot (4) into outer shell (1).
Insert inner pot at an angle to fit valve
into side opening of outer shell.
Step 4
Place basket (3) inside inner pot (4).
Step 1
Insert hinge on lid (2) into outer shell
(1). Lid will snap into place when
assembled correctly.
Note: To remove lid push tabs together on
outer shell, and pull lid up.
Step 3
Slide control panel and element (7)
down onto mounting bracket (shown
in Step 2) on side of outer shell (1).
Note: The control panel is correctly
attached when the heating element is
positioned inside the inner pot. Control
panel must be correctly attached for
appliance to operate.
A built in safety switch on control panel
will prevent element from heating if not
mounted properly.
Step 5
Insert breakaway cord (10) into connection on
outer shell (1). Make sure “This Side Up” is
shown on top for proper connection.
4
1
7
1
Tabs
2
1
Mounting
Bracket
Safety Switch
3
4
1
10
To Next Page
Loading...
