19
Step 1: Plug power cord into an outlet. Refer to “General Warnings & Safety Information” section of
manual.
Step 2: Turn dial to set temperature. Ready light will turn off when unit has reached set temperature and is
ready for use.
Step 3: When cooking time has elapsed, and food is done, turn dial to OFF and unplug power cord from
outlet.
* Allow excess grease to drain into drip cup.
OPERATING INSTRUCTIONS
OFF
ÉTEINT
APAGADO
H
I
G
H
•
H
A
U
T
•
A
L
T
O
M
E
D
•
M
O
Y
E
N
•
M
E
D
I
O
L
O
W
•
F
A
I
B
L
E
•
B
A
J
O
READY
PRÊT
LISTO
Symptom Cause Possible Solution
Ready light won’t come on Not plugged into wall Check wall connection.
Circuit breaker tripped Make sure other appliances are not
operating on the same electrical circuit.
Check circuit breakers.
Controller malfunctioning Contact Masterbuilt at 1.800.489.1581
Unit takes excessive amount of time
to heat up
Unit plugged into an extension cord Set unit so an extension cord does not
have to be used.
Door not closed properly Open, then shut door firmly.
Controller malfunctioning Contact Masterbuilt at 1.800.489.1581
Grease is leaking out of smoker Drip cup not in place Reposition so drip cup alignes to drain
hole in bottom of unit.
Excess grease or oil build-up in unit Clean unit.
No smoke No wood chips Add wood chips.
Temperature rapidly decreased, or
shut down, after few hours of use
Faulty control unit Contact Masterbuilt at 1.800.489.1581
Ready light is on, unit isn’t
heating
Controller/unit malfunctioning Contact Masterbuilt at 1.800.489.1581
Controller does not adjust heat Controller/unit malfunctioning Contact Masterbuilt at 1.800.489.1581
TROUBLESHOOTING GUIDE
To Next Page
Loading...
Need help?
General
