10 www.mastercool.com
temperature of the circuit board) and filter life (percentage of remaining filter life.)
NOTE: Check periodically for the remaining filter life. Purchase a replacement filter before
100% is reached, or you will not be able to use the machine
o VACUUM PUMP RUN TIME: Displays the total lifetime runtime for the vacuum pump. It is
recommended that you change the vacuum pump oil every 20 hours of run time. Press reset
after oil change to zero out the timer
NOTE: Failure to change the vacuum pump oil can cause damage to the vacuum pump which
may void warranty.
FILLING VACUUM PUMP WITH OIL:
1. Open the side maintenance door to access the vacuum pump.
2. Remove the red cap on top of the vacuum pump.
3. Empty the oil bottle contents into the vacuum pump.
4. Verify the oil fill; the oil should meet the oil fill line on the vacuum pump sight
glass.
5. Replace red cap and clean any excess oil.
6. Press reset after oil change to zero out the timer.
Pressing NEXT on the bottom of the screen will display last and total refrigerant recovered,
refrigerant charge, and oil injection.
The values on the left side of the screen will display the last amount of recovered refrigerant,
refrigerant charged and oil injected. The values on the right side of the screen display the lifetime
totals of recovered refrigerant, refrigerant charged and oil injected.
• SETTINGS: This will allow the user to customize the time/date, language, units and printer of the
COMMANDER machine
To Next Page
Loading...
Need help?
General
