headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
model no. 054-2437-2 | contact us 1-800-689-9928
12
TURN THE SANDER ON AND OFF
(fig 6)
The tool can be turned on or off by squeezing or
releasing the on/off switch.
LOCK-ON BUTTON
(fig 6)
1. The tool is also equipped with a lock-on button
that allows continuous operation without
continually holding the switch.
2. To lock switch “ON”: squeeze switch, depress the
lock-on button, and then release switch.
3. To unlock switch: squeeze switch, then release switch without depressing the lock-on button.
GENERAL SANDING
1. Be sure the cord is clear of the belt. Grasp the handles firmly.
2. Start the sander off of the work surface to avoid gouging the belt. NEVER start or stop the sander
with the belt in contact with the work surface.
3. Place the heel of the sander on the work surface first. Then, with a forward motion, begin the
sanding stroke as the tool is lowered onto the work surface.
4. Use short, overlapping strokes, moving the sander slowly back and forth across the work surface.
5. Avoid tilting or rocking the sander or sanding in one spot for too long. This causes gashes and
hollows in the surface. Do not apply pressure to the sander. The sander is the weighted for the
pressure needed. Too much pressure will overload the motor and reduce the belt speed.
6. Begin sanding with a coarser grit sandpaper and gradually use finer grits, until the desired finish is
achieved. Do not switch from a coarse grit to a very fine grit in one step.
7. To stop, lift the sander from the work surface, then turn the sander off. Disengage the lock-on
button. Allow the sander to come to a complete stop before setting it down. A moving belt will cause
the sander to “run away” even if the motor is off.
OPERATING INSTRUCTIONS
fig 6
Lock-on button
WARNING!
• Before sanding small workpieces, ensure the workpiece is securely held in a vise or clamp. It’s recommended to work on
the metal and wood.
• Sanding can produce clouds of fine dust particles that can ignite in the presence of sparks or an open flame. To avoid
injury, always use your sander in a well-ventilated area.
• For your safety and to avoid damage, turn the sander on and off only when the sander is not in contact with a surface.
On/off switch
To Next Page
Loading...
Need help?
General
