LITHIUM-ION BATTERY PERFORMANCE
Lithium-ion rechargeable batteries
generally provide superior performance to
nickel-cadmium batteries when used in
power tools.
● Faster charges
● Longer battery life
● More power
● Lighter weight
Lithium-ion batteries perform best and
deliver peak output power at room
temperature (20° C or 68° F). When
operated in lower temperatures, the battery
output will be reduced and it will NOT
function below –20° C (-4° F). The output
power will increase as the heat generated
by the battery during use increases the
internal temperature of the battery. The
result is increased power as the tool is
used.
DRIVING SCREWS
When driving screws, care must be taken
to use the bit that correctly fits the head of
the screw being driven. Make sure to use
the largest bit size that will properly fit into
the head of the screw. The bits must also
be in good condition and not worn so they
will drive screws without slipping out of the
screw head.
1. Select the correct screwdriver bit for
the screw being driven.
2. Insert the magnetic bit holder (1) into
the collet (2) (Fig. 9).
3. Insert the bit (3) fully into the bit holder.
4. Insert the screwdriver bit fully into the
screw head (4).
5. While holding the screwdriver firmly
against the screw and the bit aligned
with the screw, press the upper part of
the switch to start the screwdriver and
drive the screw.
6. When the screw is driven to the correct
depth, release the switch and the
screwdriver will stop.
7. When the switch is released and the
screwdriver stops turning, the spindle
will automatically lock. Fully tighten the
screw by manually rotating the
screwdriver handle in a clockwise
direction.
8. To remove screws, follow the same
general procedure as for driving
screws. When starting the screwdriver,
press on the lower part of the switch.
WARNING: Ensure to read
“POWER TOOL SAFETY”,
“SPECIFIC SAFETY RULES”,
EXTENSION CORD SAFETY” and
“SYMBOLS” on pages 3 through 7 of
this Manual before operating this
Compact Cordless Screwdriver.
Every time you the cordless
screwdriver is used, the following
should be verified:
1. Screwdriver bit is the correct
type & size, not worn and not
damaged in any way.
2. Workpiece is properly secured.
3. Safety glasses are being worn.
Failure to adhere to these safety
rules can greatly increase the
chances of injury or property
damage.
To Next Page
Loading...
